New, widened, replaced drives
Concrete Driveways in Las Vegas
A driveway that cracks across a panel or breaks at the garage slab usually has a jointing or reinforcement story underneath. We pour new Las Vegas driveways and check what's inside the old one.
Call us(725) 502-1499
Mon to Sat, 7am to 7pm. Closed Sunday.
What a driveway replacement covers
We also look at the curb and approach, the joint against the garage slab, and whether your HOA caps how wide the drive can go.
Old slab broken out
The existing driveway comes out and gets hauled away before any new work starts.
Base graded and compacted
The ground is brought to grade and compacted so the new slab sits on firm support.
Mesh on chairs, or fiber
Reinforcement is held at mid-depth on chairs, or fiber is mixed through the whole pour.
Control joints laid out
Joints are spaced and cut deep enough that panels stay close to square.
Isolation joint at the garage
A separating joint where the drive meets the garage slab lets each one move alone.
Broom finish and cure
A broom texture on top, then curing compound sprayed on so the surface doesn't dry too fast.
Why do Las Vegas driveways crack in the middle of a panel?
Las Vegas driveways will crack in the middle of the panel if the joints are too far apart, too shallow or the panel is too long. Control joints should be spaced approximately 24-30 times the thickness of the slab apart. So around 8-10ft on a typical 4-inch drive. They should be cut to at least a quarter of the depth. The panels should be close to square and shouldn't be longer than 1.5 times the width. If you go outside these measurements the slab will pick its own crack line. If the wire mesh has been laid flat on the base and never lifted it will sink to the bottom, where it does nearly nothing. Neither shows until it cracks.
Long, narrow panels
Side-by-side drives cut into long strips, where a crack splits the strip near its middle.
Crack off the garage slab
Drives poured tight to the garage floor without an isolation joint, so movement cracks one into the other.
Wire mesh or fiber: what is inside your driveway?
You can't see either in a finished slab. A broken edge or a removed panel will show mesh as rusty wire; fiber shows as fine strands in the broken face.
| What to compare | Wire mesh | Synthetic fiber |
|---|---|---|
| Where it sits | Mid-depth, about 2 inches down in a 4-inch slab | Mixed through the full depth of the concrete |
| What it controls | Reinforcing value only when held up at mid-depth | Surface shrinkage cracking while the slab is young |
| Common mistake | Laid flat on base or raked up mid-pour, then sinks | Treated as a stand-in for properly placed rebar |
| Can it sink? | Yes, unless it's set on chairs before the pour | No, it's spread through the mix itself |
| Used together? | Often paired with fiber for extra crack control | Many crews add it alongside mesh or rebar |
Driveway questions we get across Las Vegas
These come up on nearly every driveway call. Text a photo from the street showing the curb and garage.
What does a broom-finish driveway cost per square foot in Las Vegas?
A plain broom-finish driveway in Las Vegas runs about $8 to $14 per sq ft. Where yours lands depends on breaking out the old slab, any caliche in the dig, truck access, and whether curb work is involved. We can quote most drives from a few photos and measurements.
Is 4 inches of concrete thick enough for a driveway?
For cars and everyday pickups, yes. A standard residential driveway is about 4 inches thick on 3,000 to 4,000 psi concrete. Heavier vehicles push both the thickness and the strength up, so if a trailer or motorhome will park there, the slab gets built heavier for that strip.
Do I need a permit to replace my driveway in Clark County?
Usually not for the slab itself. Clark County's code exempts walks and driveways not more than 30 inches above grade from a building permit. Raised slabs, steps over 30 inches, retaining walls over 24 inches, patio covers and anything in the street need their own approvals, and HOA approval still applies.
Can you widen the driveway apron at the curb?
That's the one part of a driveway job the county controls closely. Any work at the curb or approach sits in the public right-of-way and needs a Clark County Public Works right-of-way permit, which the county issues to contractors, not to homeowners. Widening behind the sidewalk is a simpler job.
Will my HOA let me widen the driveway past the garage?
Often no. In Southern Highlands the design manual states that the driveway shouldn't be wider than the garage. If you want to make it wider you're likely to be denied. Other HOAs will have their own rules. The county also states that driveways should be at least 20ft long (18ft on cul de sac lots).
How soon can I drive on a new driveway?
Around a week. Concrete will be around 70% of its 28 day design strength after 7 days. This can vary depending on the mix. Avoid heavy trucks and trailers for longer. We'll tell you the exact date based on your mix.
Did a crack just open across the driveway?
Mark both ends with chalk and date it. Photo it with a coin for scale, note if one side sits higher, and send that to us.
Call us(725) 502-1499